Tesla Wall Connector installed for this homeowner in Tea Tree Gully after being relocated from their previous property.

‍

This one was nice and straightforward. I was able to utilise the wall cavity to get the new cabling from the switchboard through to the charger location, which meant no visible conduit work was required.

‍

Once the EV Charger was installed, I performed a factory reset and commissioned it for the new property. I also set the charging limit to suit the electrical supply available at the home, rather than simply setting the charger to its maximum output.

‍

With a battery upgrade planned for the property, I also ran an additional cable while I had access for a future CT setup. This will make it much easier to incorporate dynamic load management with the Wall Connector later on without having to run another cable.

‍

A little bit of extra work now that should save some mucking around later.

‍

Once everything was set up, I went through the charger with the homeowner and made sure everything was connected and working properly.

‍

Nice clean install, no conduit running down the wall and ready to go.