New dedicated circuit installed in Fairview Park ready for an SA Water Low Pressure Sewer (LPS) pump.

‍

This one was a bit tricky getting the 6 mm² cable from the switchboard to where it needed to go. I utilised the wall cavity and eave where I could, and had to lift a few roof tiles above the switchboard to get the cable through neatly.

‍

While I was up there, I noticed one of the roof tiles was cracked, so I replaced that for the customer while I had everything open.

‍

I installed a new 20A Type D RCBO at the switchboard and terminated the circuit into an adaptable box ready for the future connection. I also left a decent service loop inside the wall so there’s plenty of cable for whoever connects the pump equipment later on.

‍

Everything tested, safely terminated and ready to go. Nice tidy install with visible cabling kept to a minimum.

‍